Combustion that measures itself, then improves
The difference between a burner that fires and a burner that performs is the intelligence wrapped around the flame. ThermoSys engineers that layer. Burner management, flame safeguard, precise sensing and continuous trim, integrated with LAMTEC technology and proven against measured baselines.
The intelligence layer of an engineered combustion system.
These are not accessories bolted onto a burner. Each element is specified into the safety chain and the control architecture from the first drawing.
Burner management systems
Flame safeguard and BMS design, sequencing, scanner selection and retrofit, with sign-off documentation.
Electronic fuel-air control
Compound control across the full firing range, replacing mechanical linkages with repeatable precision.
O₂ trim
Continuous flue-gas oxygen measurement holding combustion at its efficient, safe operating point.
CO and advanced optimisation
CO measurement pushing efficiency further where the application and the fuel allow it.
Flame monitoring
Reliable flame supervision engineered into the burner safety chain, matched to the fuel and the furnace.
Baselining and verification
Flue-gas analysis and fuel accounting before the work, and the same measurements after it.
A closed loop around the flame, running every second.
Combustion intelligence is a loop, not a gadget. Measure the flame, decide, actuate, and measure again, continuously, across the whole firing range.
Flame
The Process
Sensing
O₂ · CO · Temp
Analysis
Against Setpoint
Control
Fuel-Air Ratio
Actuation
Valves · Dampers · Fan
Burner Response
Corrected Firing
Trend
Logged · Visible
Verified Efficiency
Measured · Reported
Project-specific control philosophy and safety chain issued with every system
We never sell the range. We measure the plant.
Savings verified against baseline.
Optimisation without a baseline is a story. Follow one combustion optimisation from first measurement to final report and see why our numbers hold up.
-
STEP 01
Baseline
The plant measured as found
Flue-gas analysis and fuel accounting on the existing setup. This number is the honest starting line.
-
STEP 02
Tuning
Combustion curves reset point by point
Fuel and air corrected across the firing range with the analyser on the flue, not by ear.
-
STEP 03
Trim enabled
O₂ trim holding the sweet spot
Continuous oxygen measurement now corrects for air temperature, fuel variation and drift, every second the burner fires.
3% Flue O₂ -
STEP 04
Verification
Measured again, same method
The same analysis repeated after the work. The difference between the two numbers is the result.
-
STEP 05
Report
A result you can file
Before and after figures, settings and curves documented and handed over. The saving has a paper trail.
Efficiency never outranks the safety chain.
Every optimisation lives inside a burner management system designed to shut the process down safely first and save fuel second. That order is not negotiable.
Explore Burner Management detailSensing technology plus the people who commission it.
Trusted
Efficiency measured, not claimed
Baselines before, analysis after, and a report in between. If the number did not move, we say so.
Lasting
Watched after the invoice
Supported systems stay connected, so trim keeps trimming and drift gets caught between service visits.